Kitchen plumbing... In Clinton MA Installations, Replacements, and Repairs
Looking for kitchen plumbing repair in Clinton? A leak under the sink, a faucet that won't stop dripping, a disposal that hums but won't grind — kitchen plumbing problems don't wait. Richard T. Curley Plumbing & Heating has served Clinton homeowners for decades with same-day kitchen plumbing repairs. From faucet replacement to full sink and disposal installation, we show up with a fully stocked truck and get your kitchen working again.
The Kitchen Business...
Richard T. Curley Plumbing & Heating has handled kitchen plumbing in Clinton since 1980. Same-day service for kitchen faucets, sinks, garbage disposals, dishwashers, gas stoves, washing machines, and dryers. We never sell you something you don’t need.
Clinton homeowners call us for three kitchen problems more than anything else: a faucet that’s been dripping for months, a garbage disposal that hums but won’t spin, and a sink that drains slower every week. Most of the time we fix it in one trip. If the fixture is too far gone, we tell you before we touch anything — no upsells, no surprises.
Every Clinton kitchen is different, but the houses share a history. Clinton is a mill town, and a lot of the homes downtown and over toward the reservoir were built between 1890 and 1920. That means original galvanized supply lines that have been corroding for a century and cast-iron drain stacks that rust and scale from the inside. We know what that old pipe does to water pressure and drainage, and we know how to fit a new kitchen fixture onto it without turning a simple faucet job into a disaster.
The multifamilies matter too. Clinton has more two- and three-family homes than most of the MetroWest towns we work, and often two or three kitchens stack along one wet wall. A new disposal or dishwasher has to tie in carefully or it’ll siphon the trap. We check that before we mount anything, and we figure out where your shutoffs actually are — in an old Clinton three-family, that shutoff is sometimes in a shared basement or behind a wall in the other unit.
Kitchen Sinks and Drains...
Kitchen Sinks… We install single-bowl and double-bowl stainless steel sinks, cast iron, and composite. If you’re doing Corian or granite countertops, we coordinate with your countertop installer for under-mount sinks — stainless or Corian, both take specific mounting hardware.
Kitchen Drain Problems… For drain problems: leaks in the trap, a strainer basket that won’t seal, a P-trap that’s rusted through. We fix all of it. If you’ve been pouring drain cleaner into a slow sink for weeks and it hasn’t helped, stop. We’ll snake it properly.
In Clinton’s oldest homes, the kitchen often started as a small pantry corner or a back room with a hand pump, so the drain line runs long and nearly flat to reach the main stack. That’s a big reason Clinton’s older kitchen sinks clog more than newer ones — and it’s a venting problem, not just a clog, when the remodel didn’t fix the slope.
- Kitchen Sink Strainers
- Traps
- Water Supplies
- Water Valves
Kitchen Faucets...
Kitchen Faucet Problems…
Kitchen Faucet Problems… Dripping, leaking at the base, a handle that spins without turning the water on — we can repair almost any kitchen faucet as long as parts are still available. If the valve body is shot or the finish is worn through, replacement costs less. We stock parts for Delta, Moen, and Kohler on the truck. We can also order any faucet you pick out and install it same-week. If you want a pull-down sprayer, a touchless sensor, or just something that doesn’t drip, we’ll walk you through what fits your sink and your budget.
Clinton note: in the older Victorians and multifamilies, the original shutoff valves under the sink are often frozen from age. We’ll test them before we unscrew anything. If they won’t seat, we swap them first so your new faucet isn’t held together by a valve that might fail next month.
- Installation
- Replacement
- Repair
- Kohler
- Delta
- Moen
- American Standard
- Pfister
- Just a few brands…
Garbage Disposals...
We can handle all of your garbage disposal problems… We can handle all of your garbage disposal problems… We install new disposals where none existed before — which comes up constantly in Clinton’s older homes that still have a plain strainer basket. We replace worn-out units. We repair jammed disposals that buzz but don’t spin, and dead ones that don’t make any noise at all. We carry InSinkErator and Waste King, and we can install any brand you choose.
Clinton note: the denser the house, the more important the tie-in. When a few kitchens share a wet wall, a disposal that isn’t vented right will pull the water out of a neighbor’s trap. We check the venting and slope before we bolt anything in.
- Installation
- Replacement
- Repair
- InSinkErator Garbage Disposals
- Waste King Garbage Disposals
- Or any brand of your choosing
Dishwashers, Gas Stoves, Washing Machines, and Dryers...
Dishwashers… For dishwashers, you buy the appliance and have it delivered. We disconnect the old unit before the truck shows up — most of the time we can schedule it so we’re there when the old one comes out and back when the new one goes in, same day. We connect the water supply, the drain line, and the electrical, then run a test cycle to confirm no leaks and proper drainage.
Clinton note: in older kitchens, dishwasher drain lines are often tied into the sink drain with a saddle fitting. Those work but clog faster than a dedicated tailpiece. If your dishwasher drains slow, we can convert it during the new install.
Gas Stove… Same process — you buy the stove and schedule delivery. We disconnect the old gas line before the crew arrives so they can haul the old unit away. We return to connect the new stove, check every fitting with a gas sniffer, and confirm the burners light properly.
Clinton note: in the old downtown homes, some gas shutoff valves are original to the building. We’ll test the valve before connecting anything to it. If it won’t seat fully or shows corrosion, we’ll tell you and swap it out
Washing Machines and Dryers…
You purchase the units and arrange delivery. On install day, we connect the washing machine hoses to the hot and cold supplies, attach the drain hose, and level the machine — an unlevel washer walks across the floor during the spin cycle. We check both hoses for leaks before we leave.
For a gas dryer, we run the gas connection and install the vent pipe properly. For an electric dryer, the vent only — the 220V outlet is an electrician’s job. We keep the vent run as short and straight as possible. Sharp bends trap lint, restrict airflow, and double drying time.
Clinton note: in an older multifamily basement, the laundry hookups sometimes share a floor drain that hasn’t seen water in years. We’ll pour water through the trap and confirm it’s open before you start your first load.
Frequently Asked Questions About Kitchen Plumbing in Clinton
Most faucet replacements run between $200 and $400 including labor. The exact cost depends on the faucet you choose and whether the shutoff valves under the sink are in good shape. In Clinton’s older homes and multifamilies, those valves are often seized from age, so if they need replacing that adds a little. We give you a firm quote before we unscrew anything.
It’s usually the age of the pipe and the way the kitchen was laid out. Clinton’s older homes started with a small pantry or back-room kitchen, so the drain line often runs long and nearly flat to reach the main stack. Over a century, cast-iron and galvanized pipe build up rust and scale on the inside, narrowing the flow. A slow drain in an old Clinton kitchen is often a slope or venting issue as much as a clog — we check both before we just snake it.
Yes, and we do it constantly in Clinton’s older homes that still have a plain strainer basket. We add the electrical if it’s needed, tie into the drain correctly, and — in the multifamilies where several kitchens share a wet wall — make sure the venting is right so the disposal doesn’t siphon a neighbor’s trap. Most of the time it’s a same-day job.
Usually the plumbing, especially in older Clinton homes. A lot of them have the dishwasher drain line tied into the sink drain with a saddle fitting, which clogs faster than a dedicated tailpiece. We can tell quickly whether it’s a clogged line, a bad fitting, or the dishwasher pump itself, and if the plumbing’s the problem, we can convert it to a proper tailpiece during the repair.
Age, mostly. In Clinton’s Victorian-era and multifamily homes, the original galvanized supply lines corrode from the inside until the pipe is choked down to a fraction of its original width. What looks like a “water pressure problem” is usually a supply line that’s rusted nearly shut. We can test it, and if the pipe is the problem, we’ll tell you straight and replace the section rather than trying to band-aid it.
Yes, in most cases. You buy the stove and schedule delivery; we disconnect the old gas line before the crew arrives and return to connect the new stove, check every fitting with a gas sniffer, and confirm the burners light. In Clinton’s older downtown homes, the original gas shutoff valves sometimes won’t seat anymore — we’ll test it first and swap it out if it’s bad, so the job gets done right rather than connected to a failing valve.
For the full scope of kitchen plumbing across every Metrowest town we serve, see our complete kitchen plumbing repair guide.
Bathroom giving you trouble, too? Our bathroom plumbing services in Clinton cover running toilets, leaky shower valves, and full vanity installations — same-day, same truck. If your kitchen remodel includes a new water heater, our water heater services in Clinton handle gas, electric, and power-vent installation and repair.
For everything else in Hudson — outdoor faucets, drain cleaning, and all your plumbing needs — see our full Clinton plumbing services page.